Warpage–Technical Problem of Fiberglass Compression Molding

Condition Description Reasons Solution
1 The Fiberglass Compression Molding part is slightly warped. Warpage due to shrinkage during hardening and cooling. To cool fiberglass molding parts in fixture.To use low or no shrinkage resin.
2 The temperature of half mold is higher than other half. Reduce mold temperature difference.
3 The Fiberglass Compression Molding part is seriously warped. Particularly long process cause fiberglass orientation and then result in warpage. To increase the feeding area,shorten the process and use low shrinkage or shrink free resin.
Project:
Warpage–Technical Problem of Fiberglass Compression Molding

Condition Description Reasons Solution 1 The Fiberglass Compression Molding part is slightly ……

Abrasion of Mold Sheared Edge–Technical Problem of Fiberglass Compression Molding

Condition Description Reasons Solution 1 Metal damage in the direction of applied force……

Why do Resins cure quickly in barrels,but slowly after pasting fabric?

Sometimes, such problems happen in the field construction:it is normal for the exothermic of the r……

Rough Fingering Orgasm Sacando La Leche Hot Vip Orgy In The Club Asian Babe Gives Deep Blowjob Pov Amateur Teen Close Up Video Casting
TOP